M2-ATX CHANGE LOG

01/15/2006 Production release
01/15/2006 Firmware release 1.1 (from M1-ATX)
04/15/2006 Rotate 12V ATX connector (mechanical issues)
04/15/2006 Connect R33 pull-up to VLIN5 instead of VCC
09/15/2007 Firmware release 1.2: Timing changes for PS_ON, 5VSB ON-delay
05/17/2007 Firmware release 1.3: Fixed PWR_OK delay at shut down
06/23/2007 Change R24 to 46.3k (12.05V output), fixed 12 V rail over-shoot
08/10/2007 Removed C1, 5V rail fix
08/10/2007 New PCB UL number UL mark: E154554
08/10/2007 Introduced serial number sticker UEC07xxxx and higher
06/06/2008 Serial number UEC0819xxx and higher
06/06/2008 C41 (was 10nF) 15nF X7R 10% 3.3/5V startup timing fix (6-26V)
06/06/2008 C35 (was 10nF) 22nF X7R 10% 3.3/5V startup timing fix (6-26V)
06/06/2008 Put back C15, 0.1uF X7R 10% 3.3/5V startup timing fix (6-26V)
06/06/2008 Firmware 1.4: Shut down while ACPI is not fully up fix via 60 second AutoLatch feature
06/06/2008 Firmware 1.4: Officially introduce3 more timing schemes: 

	0001   10 minutess / 1 hour
	1001   15 minutes / 2 hours
	0101   1 hour / 1 hour 15 minutes
NOTE: These changes were availabe in firmware version 1.3 but never advertised to the public. 

06/06/2008 Firmware 1.4: In P0 (dumb PSU mode) if ignition is used, can act as an UPS system.
(consult M2-ATX product page for more information)

=====================================================
06/18/2008 Extended availability for the next 5 years
=====================================================

06/26/2008 Serial number UEC0819xxx with silver mark or serial number higher than UEC0822xxx
Changed C35 to 15nF
Removed C15 in order to prevent rare cases in which 5V starts oscilalting at startup.